Sangean U3 (R1) - Manual (Page 12)

GB
Storing stations in preset memories
There are 5 memory presets for each waveband.
. Press the Power button to turn on the radio.
2. Tune to required station using one of the methods previously
described.
3. Press and hold down the required preset until the radio beeps.
The preset number will appear in the display and the station will
be stored under chosen preset button.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be overwritten by following
above procedures.
Recalling stations from preset memories
. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset number
and station frequency will appear in the display.
Setting the radio alarm
When the radio alarm is selected, the radio will turn on and play the
chosen radio station at the chosen alarm time. The radio alarm will
continue for one hour unless turned off by pressing the Power but-
ton. Press the Power button whilst the alarm is activated will cancel
the alarm for 24 hours.