Sangean DAR-101 (R1) - Manual (Page 16)

5
Preparing recording inputs
1. Recording with the built-in MIC
Point the microphones at the sound source and place the unit in a stable location where there is
little vibration.
2. Recording with external MIC
Connect external microphones to the MIC-L jack and MIC-R jack at the front panel. Point the
mics at the sound source and place the unit in a stable location where there is little vibration.
Note:
Built-in mics is disabled if external microphones are plugged in.
3. Recording an external device (LINE IN)
To record the signal of an external source component such as a CD player, connect the output of
the audio device to the LINE IN jack at the rear panel.
4. Recording a telephone call (please refer to later section of ‘Telephone mode’ for telephone
connection)
To record the signal of telephone calls, connect the output of a telephone to the Telephone jack
at the rear panel.