Sangean WFR-29C (V1) - Manual (Page 66)

65
Setting the alarm clock
Your radio has two separate alarms which can be set to wake you to either the radio, USB or a
buzzer alarm. In the event of a power interruption your radio has built in memory that will retain
your alarm settings. Ensure that the time is set correctly before setting the alarms.
. Press the Menu button and rotate the Tuning Control Rotary until ‘Main menu’ is highlighted.
Press the Tuning Control Rotary to enter the menu.
2. Rotate the Tuning Control Rotary until ‘Alarms’ is highlighted and the press the Tuning Control
Rotary to enter the selection.
. Rotate the Tuning Control Rotary until the desired alarm ( or 2) is highlighted on the display.
Press the Tuning Control Rotary to enter alarm setup.
4. Rotate the Tuning Control Rotary until 'Time' is highlighted on the display. Press the Tuning
Control Rotary to adjust the alarm time.
5. Rotate the Tuning Control Rotary to choose the alarm hour. Press the Tuning Control Rotary
to confirm the setting.
6. Rotate the Tuning Control Rotary to choose the alarm minute. Press the Tuning Control Rotary
to confirm the setting. The display will then return to the alarm setting menu. If the radio has
been set to use a 12 hour clock format, there will also be an option here for setting AM or PM
for the alarm time.
1
1-6
Alarm 1: Off [00:00]
Alarm 2: Off [00:00]
Alarms
Enable:Off
Time: 00:00
Mode: Buzzer
Volume: 20
Save
Alarm 1
07:00
Alarm 1- Set time
07:30
Alarm 1- Set time