Sangean WFR-27C (R1) - Manual (Page 70)

6
Setting the alarm clock - cont.
11
10,11
Alarm
Saved
Alarm 1 volume
Enable:Once
Time: 07:30
Mode: DAB
Preset: Last listened
Volume:20
Alarm 1 0.
.
Rotate the Tuning Control Rotary until the 'Volume:' option is highlighted on the display and
press the Tuning Control Rotary if you wish to change it. The radio uses the saved volume
setting for each alarm when it sounds. Set the required volume using the Tuning Control
Rotary to confirm the setting.
In order to store the alarm settings rotate the Tuning Control Rotary until 'Save' is
highlighted. Press the Tuning Control Rotary to store the alarm settings. Your radio will
show 'Alarm saved' and will then go back to the list of alarms with the new alarm setting
shown in the display. If you decide not to save the settings, press the Back button. The
display will show 'Save changes' with a 'YES' or 'NO' option. Rotate the Tuning Control
Rotary to choose 'NO' and then press the
Tuning Control Rotary. 'Alarm not saved' will
show on the display. Active alarms are shown using small alarm indicators at the bottom of
the playing displays and on the clock display when in standby.
Note:
If you make a mistake at any point while setting the alarms, use the Back button to go back
to the previous screen.