Assembly/set up, Burner tents & grates, Warming rack – Coleman 9947A726 User Manual

Page 10: Hose routing, Grease pan & grease tray, Burner assembly

Assembly/Set up

(cont.)

STEP 12

BURNER TENTS & GRATES

STEP 13

WARMING RACK

■

Install Warming Rack as shown.

■

Place Burner Heat
Tents

over

Burners as shown.

■

Install three (3)

Grates.

STEP 10

HOSE ROUTING

Orifice

Tube

STEP 11

GREASE PAN & GREASE TRAY

■

Slide Grease Tray into Grill.

Grease Pan

Grease Tray

■

Route Burner Valve at end of
Hose through hole in cart end.

■

Insert Orifice Tube into burner,
then rotate valve until valve
stem goes through hole in side
table top.

NOTE: Valve must be inserted into
Burner Inlet.

Valve

Stem

Burner

■

Align screw holes of Valve
Bracket with holes in brace.

■

Install screws and tighten.

■

Install Valve Knob on Valve
Stem.

STEP 9

BURNER ASSEMBLY

(cont.)

■

The cardboard packing
below the burners
cannot be easily
removed. It will burn
away during the first
use.

■

Note: Remove Grease Tray
and packing from rear of grill.
(This is the storage position of
the Grease Tray for shipping.)

■

Grease Pan attaches to Grease
Tray with slides.

■

Install Grease Pan as shown.

2 Required