Cybex CALLISTO - Manual (Page 15)

7
– maximum load 2 kg, maximum load for the canopy pocket 0,5 kg. otherwise the
stroller is likely to become unstable. overloading can also damage the vehicle.
– damages caused by the use of accessories not approved by CYBEX, such as rain
covers, buggy boards, bag hooks, etc. will not be covered by the terms of our
warranty.
– it may be unsafe to use replacement parts other than those approved by CYBEX.
– Before using the stroller, always check whether the accessories are well secured.
– Please make sure that the brake is locked while placing and removing the children.
– Never lift the stroller with the child inside; never ascend or descend stairs or
escalators with the child inside or when using other means of transportation.
– when opening and closing the stroller, do not use force, as incorrect folding can
damage or break the stroller. Check the instruction manual if necessary.
– drive carefully over curbs and gravel roads. The vehicle will be damaged by
repeated impact.
– make sure your child does not use the footrest to stand on.
– do not expose the stroller to any artificial heat or direct sunlight.
INSTRUCTIONS FOR MAINTENANCE
– The user is responsible for the regular maintenance of the stroller. all connecting
parts and rivets have to be tightened and secured properly. it is particularly
important to ensure that the locking and swiveling mechanism are treated regularly
with Teflon spray (dry lubricant). it is important that brakes, wheels and tyres are not
impaired during use. inspect them regularly and repair or replace if necessary. sToP
using any product that does not appear structurally sound.
– do not make any modifications to the product. if you have any complaints or
problems, please contact your supplier or importer.
– a service should be scheduled every 12 months.
– You can also treat the other moving parts with Teflon spray (dry lubricant). after
spraying on the Teflon, wipe the product with a soft cloth.
– use only original CYBEX replacement parts. it may be unsafe to use substitutes.
– The frame tubes covered by the locking mechanism and turning mechanism should
also be regularly cleaned and sprayed. This will ensure that you enjoy your stroller
without any problems.
CLEANING
– do not use abrasives to clean the frame! use a damp cloth and a mild detergent
and dry thoroughly.
– should the stroller be exposed to salt water, please rinse it down with fresh (tap)
water as soon as possible afterwards.
– seat covers are machine washable at max. 30° C on delicate cycle. The canopy
can be hand washed with mild detergent at max. 30° C.
– Please make note of the care label. do not tumble dry. Let covers dry completely
before reuse.
– all CYBEX fabrics have been tested, but when the stroller is very wet, the water
may permeate the lining through the bottom edges and seams and leave water
stains on the upholstery. we advise you to use a rain cover to avoid this. also please
do not fold or store the product while wet. if the stroller is wet, allow to dry with the
canopy extended. Never store in a damp environment as this can cause mildew
to form.
Note! Please wash the cover separately before you use it the first time. do not tumble
dry and do not expose to direct sunlight! do not iron!
THIS PRODUCT WAS APPROVED ACCORDING TO THE
EN1888:2012 STANDARD.
INSTRUCTIONS FOR USE
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE. YOUR CHILD’S
SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE
INSTRUCTIONS.
1. OPENING THE STROLLER
a) Before opening the pushchair the safety lock needs to be released.
b) after releasing the safety clip you can unfold the pushchair.
c) step on the footboard until it locks in place with an audible click.
d) Please make sure that the handle bar is safely locked as well.
2. ASSEMBING THE WHEELS
a) b) front wheel assembly.
c) Remove the front wheels.
WARNING: CHECK THAT THE SEAT UNIT ATTACHMENT DEVICES
AND CARRYCOT/CAR SEAT ADAPTERS ARE CORRECTLY
ENGAGED.
5. USING THE HARNESS SYSTEM
a) To fasten the harness system insert left and right side fasteners into the central
harness buckle.
b) To tighten the belts pull the strap on the front of the central harness buckle.
c) To release the belt system press the release button located on the seat in front of
the belt lock while pulling at the shoulder belts.
d) To release the fasteners squeeze the grooves on left and right side of the central
harness buckle.
e) adjust the length of the crotch strap with the corresponding slider under the seat
cover.
3. AUTOMATIC FRONT WHEEL SWIVEL LOCKS
4. USING THE BRAKES
– Regardless of their position, the front wheels can be automatically locked into
place by stepping on the lock button (wait for an audible CLiCK). To release the
lock press again until you hear a CLiCK.
– Tilt the lever located at the right wheel to secure the brake. To release the brake tilt
the lever again.
6. ADJUSTING THE HARNESS SYSTEM FOR NEWBORNS
– Release the loops at the end of the shoulder straps from the triangle in the belt
system, situated at the bottom of the backrest under the seat cover.
– Completely pull the shoulder straps out of the holes in the backrest.