Dmx channel map – Zylight Remote User Manual
Page 7

7
DMX Channel Map
Slot 1: ZyLink Channel Enable - This control disables broadcast on the
respective ZyLink channel when under 50%, and enables broadcast when
above 50%.
Slot 2: Shutter - This control turns the light off when under 50%, and turns the
light on when above 50%. It is equivalent to the power button on the Z90.
Slot 3: Mode. -This control changes the mode of the Z90. From 0-33% the light
is in White mode. From 33-66% the light is in Gel mode. From 66-100% the
light is in Color mode.
Slot 4: White Mode Color Temperature - This control changes the color
temperature while in White Mode. From 0-50% the light outputs Daylight
(5600K), and from 50-100% the light outputs Tungsten (3200K).
Slot 5: Gel Mode Color Temperature - This control changes the color
temperature while in Gel Mode, from 2500K (0%) to 9000K (100%).
Slot 6: Color Correction - This control changes the color correction while in Gel
Mode, from -10 (0%) to +10 (100%). If no color correction is desired, leave
this channel at 50%.
Slot 7: Color Hue - This control changes the hue while in Color Mode. It follows
an R-G-B-R color wheel.
Slot 8: Fine Color Hue - This control fine-tunes the hue while in Color Mode,
allowing finer color selection. This control can also be used with computerized
faders to allow smoother color fades.
Slot 9: Saturation - This control changes the saturation while in Color Mode,
from 0% (white) to 100% (fully saturated color).
Slot 10: Intensity - This control adjusts the intensity from 0% (minimum
brightness) to 100% (maximum brightness). Please note that to preserve color
fidelity, lights cannot turn off completely at minimum intensity. Use the Shutter
(Slot 2) to turn off the light completely.
Slot 11: Fine Intensity - This control fine-tunes the intensity, allowing finer
intensity selection. This control is best used with computerized faders to allow
smoother intensity fades.