beautypg.com

Waterworks Opus Wall Mounted Single Arm Sconce with Cylinder Shade User Manual

Installation guidelines

background image

Connect Fixture Wires
To 120 V Electrical Service
Install And Ground
Per N.E.C. And Local Codes

Verticle Mount Only

Shade

Retaining

Ring

Glass Shade

O-Rings

75 Watt Max

Standard Base

T8 Showcase

Lamp (Frosted)

Fixture Body

#6-32 Cap
Screws (2) (Supplied) - 7/64" Hex

Mounting
Box

Horizontal Mount
J Box (Not Supplied)
2" X 3

1

/

2

" Swith Box

Type Only (Not Supplied)

#6-32 J-Box Screws
(Not Supplied)

Opus Single Sconce

7/04

W A T E R W O R K S

These guidelines have been prepared for the professional contractor to aid in the installation of:
OPUS SINGLE SCONCE

All dimensions are based on original specifications and are subject to change and variation.
Please consult your Design Associate for current specifications.

Installation Guidelines

1

Figure 1

4

1

/

4

"

2

1

/

2

"

11

3

/

8

"

13

1

/

2

"

2

1

/

2

"

1

7

/

8

"

13

3

/

4

"

2

3

/

8

"

Ш

2

3

/

8

"

Ш

2"

Notes:
• Bulb: T8 standard base frosted
showcase; 75 watt max.
• Sconce must be mounted
vertically.
• Electrical J-box: 2" x 3

1

/

2

" switch

type, mounted horizontally.

OPLT01

Figure 2

INSTALLATION

➢ IMPORTANT: Check to ensure the power supply has been turned off prior

to starting installation.

1. Install an electrical J-box (2"x3 ½" switch type ) horizontally making sure to

use supply connection wire that meets local codes and is rated for at least
90° C / 194° F.

2. Inspect this product to assure you have all parts required for proper

installation.

3. Connect the wires from the fixture to the wires in the J-box as shown in

Figure 1.

4. Unthread and remove the shade retaining ring from the fixture body.

5. Mount the fixture body to the mounting box as shown in Fig. 2 using the

#6-32, 7/64" hex screws (supplied).

6. Install a 75 watt max.T8 standard base frosted showcase bulb.

7. Slide the o-rings toward the flared-end of the glass shade.

8. Insert the flared-end of the glass shade into the fixture body and slide the

shade retaining ring down over the glass shade.

9. Hand-tighten the shade retaining ring to secure the shade to the fixture

body.

➢ If further assistance is required, please contact product support at

1-800-927-2120 (8am-7pm EST).

Fixture wires

House wires

Black

White

Bare copper

(ground)

Black

White

Green

(ground)