Operation, Warning, Clamping wide workpieces – Ryobi TS1340 User Manual
Page 25: Cutting warped material, Page 25, Wrong, Save right end of cut 33.85, Fig. 34, Fig. 33
Page 25
0
15
30
45
0
15
30
45
33.6
22.5
22.5
33.6
WRONG
WARNING:
To avoid a kickback and to avoid serious personal injury,
never position the concave edge of bowed or warped
material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 34.
When cutting wide workpieces, such as 51 mm x 152 mm
(52 in. x 6 in.), boards should be clamped with a C-clamp as
shown in figure 34.
Bevel
Angle
Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62
°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62
°
3. Save right end of cut
33.85
°
33.85
°
33.85
°
33.85
°
Fig. 34
CUTTING WARPED MATERIAL
See Figures 32 and 33.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against the
fence as shown in figure 32.
If the warped material is positioned the wrong way as shown
in
figure 33, it will pinch the blade near the completion of the
cut.
Fig. 32
RIGHT
WIDE
BOARD
OPERATION
Fig. 33
15
30
45
0
15
30
45
33
.6
22.5
22.5
33.6