Ryobi P712 - Manual (Page 5)

5 — English
ASSEMBLY
UNPACKINg
This product has been shipped completely assembled.

Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKINg LIST
Dry Hand Vac
Brush/Crevice Attachment
Tool/appliance/battery pack/charger
correlation supplement 987000-432
Operator’s Manual
WARNINg:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Failure to heed
this warning could result in serious personal injury.
WARNINg:
Do not allow familiarity with the product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNINg:
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
result in objects being thrown into your eyes, resulting in
possible serious injury.
WARNINg:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:

Light-duty vacuuming of dry surfaces
This product will accept Ryobi One+ 18 V lithium-ion
battery packs and Ryobi One+ 18 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator’s
Manuals for your Ryobi One+ battery pack and charger
models.
TO INSTALL/REMOVE BATTERY PACK
See Figure 1, page 7.
WARNINg:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
OPERATION
 Place the battery pack in the hand vac. Align the raised
rib on the battery pack with groove in hand vac’s battery
port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
hand vac before beginning operation.
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hand vac.
STARTINg/STOPPINg ThE VACUUM
See Figure 2, page 7.

To start the vacuum: slide the switch toward the front
of the vacuum.
 To stop the vacuum: slide the switch toward the back
of the vacuum.
BRUSh/CREVICE ATTAChMENT
See Figures 3 - 5, page 7.
The combination brush/crevice attachment is conveniently
stored on the underside of the dust bowl.
To detach the brush/crevice attachment, pull it forward and
remove it from the dust bowl.
The cover of the brush/crevice attachment slides forward
to cover the brush so the attachment can be used as a
crevice tool.

Turn off the vacuum.
 Remove the battery pack.
 Insert the attachment into the front end of the vacuum
dust bowl, making sure the attachment is firmly pushed
into place.
When purchasing replacement brush/crevice attachment,
request recommended part number 019484001011.