beautypg.com

Operation – Ryobi P221 User Manual

Page 9

background image

9 — English

OPERATION

USING THE AUXILIARY HANDLE ASSEMBLY

See Figures 5 - 6, page 13.
An auxiliary handle is packed with the drill for ease of opera-
tion and to help prevent loss of control. The handle can be
mounted on the opposite side for left or right hand use.

ADJUSTING THE AUXILIARY HANDLE
ASSEMBLY

See Figure 5, page 13.

Loosen the auxiliary handle by turning the auxiliary handle

counterclockwise.

Insert the auxiliary handle assembly in the desired

operating position.

Securely tighten by turning the auxiliary handle

clockwise.

NOTE: Be sure the auxiliary handle is securely tightened

against the depth stop rod clamp. This secures the depth

stop rod at the desired depth of cut. It also secures the

auxiliary handle.

ADJUSTING THE DEPTH STOP ROD

See Figures 4 - 5, pages 12 - 13.
The depth stop rod helps control the depth of drilled holes.

For convenience and ease of starting threads, the hex nut has

been trapped inside the molded slot in the auxiliary handle.
To adjust the depth stop rod:

Lock the switch trigger by placing the direction of rotation

selector in the center position.

Loosen the auxiliary handle assembly by turning the

auxiliary handle counterclockwise.

Adjust the depth stop rod so that the drill bit extends

beyond the end of the rod to the required drilling depth.

Tighten the auxiliary handle assembly by turning the

auxiliary handle clockwise.

NOTE: When properly installed, the teeth on the depth stop
rod should be aligned with the teeth indicator on the depth
stop rod clamp.

FITTING AND CHANGING SDS BIT

See Figure 6, page 13.
This tool is equipped with an SDS Plus connection system.

Clean the bit and grease it with machine grease before

inserting it into the chuck.

Pull back the clamp collar and hold it.

Push and rotate the dust-free tool into the bit holder as

far as it will go.

Release the clamp collar to lock the bit.

Check that bit has locked by pulling on it.

REMOVING THE BIT FROM THE SDS PLUS
SYSTEM

See Figure 6, page 13.

Pull back the clamp collar and remove the bit.

CHUCK ADAPTOR (NOT INCLUDED)

See Figure 7, page 13.
For drilling in metal, wood, and plastic with drill bits that have
non-SDS Plus shaft, a chuck adaptor is available.

SLIP CLUTCH

If the tool becomes jammed or gets caught, the slip clutch

releases. Remove the load from the machine immediately
by pulling back the drill.

MODE SELECTOR

See Figure 8, page 13.
The mode selector allows you to quickly switch from rotary
mode to hammer mode.
In general, rotary mode should be used for drilling and other
heavy duty applications. Hammer mode should be used for
hammer drilling.

For drilling, place the selector in the ( ) position.

For hammer drilling, set mode selector to (

).

Switch between modes when tool is at a standstill.
NOTE: Hammer drilling mode will damage the tool’s
mechanism when used for fastening or drilling by non-SDS
Plus bits. Select the rotary mode only on such purpose.
When hammer drilling, use only bits with hard metal and
SDS Plus shaft only. The use of commercially available
masonry bits with cylindrical shaft by means of the drill
adaptor is impossible.

CAUTION:

When hammer drilling, do not apply too much pressure.
Too much pressure will place unnecessary load on the
motor.

CAUTION:

To prevent gear damage, always allow the chuck to
come to a complete stop before changing the direction
of rotation.

To stop the drill, release the switch trigger and allow the
chuck to come to a complete stop.
NOTE: The drill will not run unless the direction of rotation
selector is pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the drill to become overheated. If this occurs, cool the
drill by running it without a load and at full speed.