Ryobi RY64400 - Manual

RYOBI ART WORK
Art Part No. : 987000-682 Rev. 03
Where Used : 987000-682
Refer to Drawings for Dimensions.
987000-682
10-15-10 (REV:03)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
To Start:
To Stop:
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
Press the PRIMER BULB 10 times slowly or until fuel appears.
Pull starter grip sharply until engine attempts
to run (no more than 4x).
1 GALLON
GAS
10x
1
2
3
7
Pull starter grip until engine runs (no more than 6x).
NOTE: If engine does not start, return to step 6 and
repeat.
9
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
Place the STOP SWITCH in the ON position (I).
4
First time use only: Pour entire contents of engine lubricant bottle into oil fill hole using a funnel.
Later uses: Check engine lubricant level and add lubricant if needed.
For any questions about operating or maintaining your product, call the Ryobi ® Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ryobitools.com
1
12
Place the STOP SWITCH in the OFF position (O).
5 Lean the unit back on its wheels so that the
handlebar rests on the ground.
9
Move to the rear of the machine and
sq ueeze throttle lever to operate.
11
11
2
5 7
3 12
4
Set CHOKE lever to " FULL CHOKE".
6 FULL
CHOKE
Set CHOKE lever to " HALF CHOKE".
8 HALF
CHOKE
Allow engine to run 10 seconds, set CHOKE lever
to " RUN ".
10
RUN
10
6 8