beautypg.com

Troubleshooting, Maintenance – Ryobi RB60G User Manual

Page 9

background image

9 – English

TROUBLESHOOTING

Problem

Possible Cause

Solution

Wax does not go on evenly.

Too much wax on the bonnet.

Remove a portion of the wax and
retry.

Polishing seems difficult.

Bonnet may be worn.

Replace bonnet.

Polisher does not turn on.

Bad connection to receptacle.



Problem with motor.

Check to make sure plug is properly
seated in outlet. If using an exten-
sion cord, check connection and wire
gauge.
Call authorized service center.

Pad spins slower than normal or not
at all.

Motor needs to be serviced or
replaced.

Call authorized service center.

MAINTENANCE

Electric tools used on fiberglass material, wallboard, spackling
compounds, or plaster are subject to accelerated wear and
possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommended
using this tool for extended work on these types of materials.
However, if you do work with any of these materials, it is
extremely important to clean the tool using compressed air.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.

POWER SUPPLY CORD REPLACEMENT

If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.

APPLICATION AND BUFFING/POLISHING
BONNETS

Both the application and buffing/polishing bonnets are
reusable. For maximum life and performance, hand wash
after use and allow them to air dry. If needed, the bonnets
can be machine washed in cold water with a small amount
of detergent, then machine dried using low heat.

FOAM PAD

It is important that the pad retain its original shape and
dimensions. Allow it to dry completely after each use. Make
sure to remove the bonnets, wash them, and store separately.
Polisher should be stored with the pad facing up in order to
extend pad life and retain its shape. Be careful not to use
too much polish at one time. If the pad becomes saturated,
it will not last as long.

NOTE: ILLUSTRATIONS START ON PAGE 10

AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

This manual is related to the following products: