Ryobi BGH6110 - Manual (Page 10)

10 — English
ASSEMBLY
MOUNTING GRINDER TO WORKBENCH
See Figure 5, page 14.
The bench grinder must be mounted to a firm supporting
surface such as a workbench or leg stand. Four bolt holes
have been provided in the tool’s base for this purpose. Each
of the four mounting holes should be bolted securely using
machine bolts, lock washers, and hex nuts (not included).
Bolts should be of sufficient length to accommodate the
saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make sure
that no movement can occur during use. If any tipping, slid-
ing, or walking is noted, secure the workbench to the floor
before operating.
MOUNTING SAFETY SHIELD ASSEMBLY
See Figure 6, page 14.

Attach the safety shield assembly and bracket to the wheel
guard using a clamp bracket, washer, and hex head bolt.
 Tighten bolt securely.
 Repeat above steps for the other side.
MOUNTING SPARK DEFLECTOR
See Figure 6, page 14.

Using the two phillips head screws, washers, and lock
washers, attach the spark deflector to the top of the wheel
guard.
 Adjust the spark deflectors to within 1/16 in. (1.6 mm) of
the grinding wheel. Tighten screws securely.
MOUNTING WORK REST
See Figure 7, page 15.

Unscrew and remove the carriage bolt from the work rest
knob.
 Attach the work rest to the inside of the wheel guard as
shown.
NOTE: As the diameter of the wheel decreases with use,
adjust the distance between the wheel and the work rest
to maintain 1/16 in. or less separation.
 Tighten knob securely.
UNPACKING
This product requires assembly.

Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the Loose Parts
are included.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn’t hit the
grinding wheel.