Assembly – Ryobi BGH616 User Manual
Page 12
1
WaSHer
CarriaGe
bolt
WorK
reSt
aSemblY
Fig. 6
Knob
Pin
ASSEMBLy
MOUNTING WORK REST
See Figure 6.
Remove the knob, star washer, and washer from the car-
riage bolt on the lower portion of wheel guard.
Using the slotted screw, star washer, washer and fasten-
ing knob, attach the work rest bracket to the inside of the
wheel guard as shown.
NOTE: The grooved work rest mounts on the left side.
NOTE: The work rest bracket's lower slot must be posi-
tioned over the pin on the guard.
With the remaining fastening knob, install the work rest
to the bracket.
NOTE: Adjust the distance between the wheel and the work
rest to maintain 1/16 in. or less separation as the diameter
of the wheel decreases with use.
WARNING:
Always make sure your bench grinder is securely
mounted to a workbench. Failure to do so could result
in an accident resulting in possible serious personal
injury.
MOUNTING GRINDER TO WORKBENCH
See Figure 7.
If grinder is to be used in a permanent location, it should be
fastened securely to a firm supporting surface, such as a
workbench with bolts.
Use 1/4 in. bolts, washers, and nuts (not included). The
bolt length should be 1-1/ in. plus the thickness of the
workbench.
Locate and mark the holes where the grinder is to be
mounted.
Drill four 3/8 in. diameter holes through workbench.
Place sander on workbench, aligning holes in base with
holes drilled in workbench.
Insert four 1/4 in. diameter bolts and washers and attach
nuts securely.
Fig. 7
WorK reSt
(riGHt)
larGe
Knob
WorK reSt
braCKet
Star WaSHer
Fig. 6
HeX nut
loCK
WaSHer
WaSHerS
WaSHer
HeX bolt
WaSHer