Ryobi P115 - Manual (Page 7)

7 — English
OPERATION
 After charging is complete, the green LED will remain on
for one hour, indicating Maintenance Mode.
 After completing maintenance mode, the green LED
will begin fading on/off continuously. This indicates the
battery is fully charged and the charger is in Energy Save
Mode.
 The charger will remain in Energy Save Mode for 5 days
before it resumes charging the battery.
 To remove the battery pack from the charger, depress the
latches on each side of the battery pack.
CHARGING A HOT BATTERY PACK
If the battery pack is above normal temperature range, the
red LED will begin flashing and the green LED will be off.
When the battery pack cools down to approximately 122°F,
the charger will automatically begin fast charge mode.
CHARGING A COOL BATTERY PACK
If the battery pack is below normal temperature range, the red
LED will begin flashing and the green LED will be off. When
the battery warms to a temperature of more than 32°F, the
charger will automatically begin fast charge mode.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.