Night Optics IR-K2 Pro Extra Long-Range IR Illuminator (805nm) - Manual (Page 5)

1
2
3
OPERATION
3
Battery Installation
• Remove battery cap/power switch - Insert [1] 3v CR123 (negative first).
• Replace battery cap/power switch securely.
Using the Variable Power Switch
• Turn the variable power switch (fig. 1.6) to the desired
output level. (example below)
Power Output/Controls
100% | Off% | 50%
[1] Mount Point/Screw [3] * Windage/Elevation Adjust.
[2] * Windage/Elevation Adjust.
MOUNT BREAK-DOWN Figure 3
Figure 2
Variable Power Switch
Battery Cap
Mount/Windage & Elevation
• To mount the IR-K2 Pro, align the mount point to device or rail adaptor
and use the mount screw (Fig. 3.1) to tighten.
• The IR-K2 Pro can be Zeroed to the night vision/weapon by adjusting the
Windage and Elevation (Fig. *3.2 & 3.3) knobs.
*Adjustment dependant on mounting orientation