Night Optics Krystal 950L Generation 2+ B/W Clip-on Sight - Manual (Page 7)

6 NIGHT VISION
OPERATION
¡WARNING!
Do not turn the device ON during daytime without the protective lens
cap/daylight filter on. Failure to do so can damage the device.
MOUNTING PROCEDURES
Attach the “Throw-lever adapter to front objective lens of the daytime scope. On the
night vision device, loosen the Krystal 950 dioptic ring fastener (fig. 1-8 - if applicable).
While holding the scope in place, attach the Krystal 950 by turning the device or dioptic
ring counter clockwise until tight. Secure the scope by tightening the dioptic ring
fastener (if applicable.)
Rotate the Krystal 950 focus adjustment knob for a sharper image. This works incon-
junction the focus on the daytime riflescope. The manual gain control can be used to
brighten or darken the image based on lighting conditions.
ACCESSORY MOUNT
The Krystal 950 features a built-in picatinny accessory rail mount (fig. 1-9). This mount
can be used for external attachments like IR Illuminators or laser devices, it can also be
used to mount the night vision directly to the rail.
For IR mounting, attach the 1913 weaver rail (Sku: IR-WM) to the Krystal 950 accessory
mount and fasten in place. Now attach the IR Illuminator to the mount by aligning the
1/4-20 screw with the whole or tightening the screw until secure. Finally ensure that
there is no free play in the IR Illuminator mount.
NOTE
The IR Illuminator is a light that is invisible to the unaided eye for use during
conditions of extreme darkness. However, the light from the illuminator can be
detected by using night vision equipment.