myCharge Summit 3000 RFAM-0165 User Manual

Page 3

Thanks for choosing myCharge.

In The Box

• myCharge Summit
• Owner’s Manual
• Warranty Manual

Section I: Quick Start

1. Charge up your Summit in one of two ways: use the fold-

out prongs on the back of the unit for fast-charging via wall

outlet or extend the USB charging cable located on the

side of the unit to plug into your laptop’s USB port.

2. As Summit charges, LEDs on the unit will sequentially

illuminate. When the unit is fully charged, all LEDs are

lit. Press the level check button to see how much power is

available.

3. Summit comes equipped with Apple 30-pin and Micro-

USB connectors, as well as a built-in USB port for use with

your own cable. Connect your device(s) to one of the

various inputs available. Charge up to three devices

simultaneously by using all connectors and USB port.

4. Unplug your device when it's charged and go! Your

Summit will automatically power off after your devices are

unplugged.

Section II: Charging Summit

The fastest way to charge Summit is via the fold-out wall
prongs – simply plug it into a wall outlet. When you are
away from an outlet, connect Summit to your computer’s
USB port and charge via the on-board green USB input
cable.

Times to charge the Summit vary based on what it’s
plugged into. You can expect a full charge from the wall in
about two hours or from a standard notebook USB port in
about five and a half hours.

Note: It is normal for your Summit to be warm to the touch
while in use.

USB Charging
Cable

Apple 30-pin
Connector

Micro-USB
Connector

USB Port

LEDs

Multifunction
Button

Wall Prongs

Charge from the wall or your computer