Combi 7100 Series - Manual (Page 8)

CAUTION
Failure to fully secure the canopy holders can
cause the holders to bend. When storing the stroll-
er by laying it down, be sure the canopy is off the
ground to prevent it from bending.
Extending
Attaching
Removing
Folding
Air-Thru Window
Using the Canopy
Fully insert the canopy
holder (male) to the
canopy holder (female)
until a click is heard.
Press lock down to
fully extend canopy.
Pull tab on canopy up
and pull out of canopy
holder.
Push lock up to fold
canopy.
Using the Air-Thru System
Open and close the Air-Thru window using the
zipper located at the rear of the canopy.
Backrest
Headrest
Removing and Attaching the Seat Cushion and Eggshock Pad
Removing
1. Unbuckle the 5-point harness and pull all the straps
through the seat cushion.
2. Unsnap seat cushion from seat extension.
3. Unhook elastic bands from backrest.
4. Grasp seat cushion and Eggshock foam and remove from
seat.
Attaching
1. Pass the 5-point harness straps through the appropriate
locations in the Eggshock foam and seat cushion.
2. Fit seat cushion over backrest.
3. Attach all elastic bands.
CAUTION
If seat cushion is ripped or torn, do not use.
Do not use the stroller without the seat
cushion.
WARNING
Always ensure at least 1.2 inches of waist
belt is visible after routing is complete.