Magnum Dynalab MD-108 - Manual (Page 4)

4
UNPACKING YOUR MD 108
Carefully inspect all sides of the shipping carton for damage. If there are marks or holes in the
carton make note of the location in relation to the unit inside. Any obvious dents or scuff marks
should alert you to the possibility of damage. Open the top flaps and carefully lift the transport
case out of the carton. Carefully remove the MD 108 from the end caps and wrapping, inspect all
sides. Pay special attention to the corresponding areas on the unit where damage was found to
the shipping carton. If damage is evident, document the type and extent of the damage, then
repack the unit and call the dealer.
If your unit was delivered by a common carrier (Eg. UPS) and you have found it to be damaged,
contact the carrier immediately for instructions.
KINDLY DO NOT SEND THE UNIT BACK TO THE SHIPPER UNTIL YOU HAVE
BEEN ASKED TO DO SO. SHIPPNG THE UNIT BACK PREMATURELY MAY VOID
ANY CLAIM FOR DAMAGE THAT YOU MAY HAVE.
DO NOT DISCARD THE PACKING MATERIALS AND CARTONS. Should there be a
necessity to return the unit for any reason, it must arrive safely and suitably packaged in order for
our receiver to accept it from the carrier. Also, if the unit has incurred damage as a result of
improper packaging, it is not likely that a claim for the damage against the carrier will be
successful.
Likewise, we will ship your unit back to you only in factory-approved packaging, However, if
the unit were to arrive at the factory on anything other than factory approved packaging, we
reserve the right to return same in factory-approved packaging and charge the cost of the
packaging to the shipper. This is the only way we can assure you of a safe return (damage by
carrier excepted).