Coleman 9971-A50 - Manual (Page 6)

Grill Assembly
1. Install drip tray below front of grill. (Fig. 1).
2. Insert tab on heat tent into slot in back bracket of grill. (Fig. 2)
3. Insert tab on bottom right side of heat shield to lock into slot on
grill bracket.(Fig. 3)
4. Install the remaining heat shield as shown (Fig. 4).
IMPORTANT: Remove all protective plastic film from stainless
steel parts and any packing materials from grill prior to
assembly/use. This film or packing materials are installed at the
factory to prevent damage that could occur during shipment
and handling.
Fig. 2
Fig. 3
Fig. 4
Fig. 1
6