Craftsman 316.79614 User Manual
Page 5
5
Cutting
Attachment Shield
Fuel
Cap
Throttle
Control
D-Handle
HassleFree lll™
Shaft Grip
Primer
Bulb
Oil Fill Plug
Choke
Lever
Spark
Plug
Shaft
Housing
Starter
Rope
Grip
Line
Cutting
Blade
Muffler
Twist & Edge
and Craftsman
Convertible™
Coupler
On/Off Stop
Control
KNOW YOUR TRIMMER
Air Filter
Cover
ASSEMBLY INSTRUCTIONS
INSTALLING AND ADJUSTING THE D-HANDLE
To Install
1.
Place the D-handle down on to
the shaft housing and the bottom
clamp so that the handle slants
toward the shaft grip (Fig. 1).
Place handle and clamp a
minimum of 6 inches from the
end of the shaft grip.
2. Start screws with a large Flat-
head or T-25 Torx screwdriver.
Do not tighten until the handle is
adjusted.
To Adjust
3.
While holding the unit in the
operating position (Fig. 2),
postion the D-handle to the
location that provides you the
best grip.
4.
Tighten the clamp screws evenly, until the D-handle is
secure.
INSTALL LINE TRIMMER ATTACHMENT
NOTE: To make installation easier, place the unit on the
ground or on a workbench.
1.
Turn knob counterclockwise to loosen coupler (Fig. 15, p.
8).
2.
While firmly holding attachment, push it straight into the
coupler until the release button snaps into the primary hole
(Fig. 16, p. 9).
NOTE: Aligning the release button with the guide recess (Fig.
16, p. 9) will help installation.
3.
Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative
trimming around trees, fences, etc.
Fig. 1
(4) Screws
Shaft Grip
Shaft
Housing
On/Off Stop Control
Minimum 6 Inches
(15.24 cm)
D-Handle
Bottom Clamp
Fig. 2