Crosley Radio Bubbler iJuke CR16 - Manual (Page 5)

4
Control Locators
Unit Controls
1 FM Tuner
2 Tuning
3 Light On / Off
4 Power
5 Program Indicator
6 Repeat Indicator
7 Play / Pause Indicator
8 Mute Indicator
9 Remote Sensor
10 Stand By Indicator
11 Power Indicator
12 CD Drawer
13 Remote Holder
14 Speaker Int. & Ext.
15 Speaker Jacks
16 FM Antenna
17 A/C Power Cord
18 Line In Jack
19 Line In ON/OFF Switch
20 Stage light Stop & Run Switch
LINE IN LINE IN
ON OFF
SPEAKER
R SP- L INT. EXT.
STOP RUN
STAGE LIGHT
R SP+ L
19
18
15
14
16
13
17
20
10
11
8
9
5
6
7
12
4
2 3 1
1 This radio is equipped with external speaker
outputs.
2 The speaker jacks for external speakers are
located on the back of the radio. Beside the
speaker jacks is a switch labeled (int./ext.) When
using external speakers, this switch must be
switched to the ext. position. Doing this turns off
the internal speakers in the radio and redirects
to power to the external speakers.
3 If you decide not to use the external speakers,
be sure the switch is on int. or the internal
speakers will not work.
1 You can connect external components to your
unit by using the Auxiliary Inputs.
2 Plug one end of the supplied auxiliary cable into
the LINE IN JACK (18) on the back of the
jukebox.
3 Switch the LINE IN ON/OFF (19) to the ON
position.
4 Plug the other end other auxiliary cable into the
output jack of your external device.
5
Check the volume level of your external
component.
6 See operators manual for correct operation of
the external component.
External Speakers
Auxiliary Inputs
Lights / Bubble Tubes
FM Stereo Operation
Remote Control
7
Basic Operation Connecting Optional Equipment
1 Gently pull on top right side of tuner door to open.
2 Press light button in to turn lights on.
3 Bubble tubes will begin to bubble in approximately
15-20 minutes after lights are turned on.
4 Bubble tubes will not bubble unless lights are on.
1 Press the Power (21) button to turn the power
ON/OFF.
2
Press CD/RADIO (26) to select the CD player or
radio mode.
3
Use VOL+ (31) and VOL- (32) to adjust the
volume level.
4 Press the MUTE (29) button to mute the volume
completely.
5 The remaining controls are specific to the CD
player. See CD OPERATION for information on
CD player.
1 Turn power on using either the remote or power
button located behind tuner door.
2
Press CD / RADIO BUTTON (26) to enable FM
tuner.
3
Turn the Tuning (2) wheel to set the FM dial to
the desired station.
4 Position FM ANTENNA (16) for best reception.
5 Set the volume to the desired listening level by
using the remote control.