Chicago Electric 7" Electronic Polisher 66615 - Manual (Page 13)

Page 13 For technical questions, please call 1-800-444-3353. SKU 66615
Allow sufficient time for the polishing 11.
liquid or wax to dry on the object.
To Polish an Object:
Attach the Polishing Bonnet (52) to 1.
the Mounting Disc (51) as previously
discussed in this manual.
(See Figures a and B.)
Plug the Power Cord (5) into the nearest
2.
120 volt, grounded, electrical outlet.
In order to keep the Power Cord (5) out
3.
of the way, hang it over your shoulder.
IMPORTaNT: Start and stop the Polisher only
while it is held firmly against the surface
of the object being polished. Failure to
do so may result in the Polishing Bonnet
(52) being thrown from the Mounting
Disc (51).
Grip the Polisher firmly with both hands.
4.
Then turn the Power Switch (11) to its
“ON” position. (See Figure C.)
Increase the tool’s speed by pressing
5.
the + Speed Button (13). Decrease the
tool’s speed by pressing the – Speed
Button (13). (See Figure C.)
The Display (10) will indicate the tool’s 6.
speed.
Begin polishing the object by lightly
7.
buffing off the polishing liquid or wax
residue in broad sweeping strokes in a
figure eight pattern. Continue polishing
until all the residue is removed.
IMPORTaNT: Apply minimal pressure on the
Polisher to avoid damaging the surface
of the object.
After the polishing liquid or wax has
8.
been removed from the object’s surface,
slide the Power Switch (11) to its “OFF”
position. Then unplug the Power Cord
(5). (See Figure C.)
Remove the Polishing Bonnet (52) 9.
from the Mounting Disc (51). With the
Polishing Bonnet in your hand, remove
the polishing liquid or wax from all hard
to reach areas of the object.
(See Figures a and B.)
To Sand an Object:
Attach the Sanding Disc (54) to the 1.
Mounting Disc (51) as previously
discussed in this manual.
(See Figures a and B.)
Plug the Power Cord (5) into the nearest
2.
120 volt, grounded, electrical outlet.
In order to keep the Power Cord (5) out
3.
of the way, hang it over your shoulder.
Grip the Polisher firmly with both hands.
4.
Then turn the Power Switch (11) to its
“ON” position. (See Figure C.)
Increase the tool’s speed by pressing
5.
the + Speed Button (13). Decrease the
tool’s speed by pressing the – Speed
Button (13). (See Figure C.)
The Display (10) will indicate the tool’s 6.
speed.
Once the Sanding Disc (54) is turning
7.
at the desired speed, sand the object
evenly with gentle, broad, sweeping
strokes in a criss-cross pattern.
During the sanding process, it may
8.
be necessary to occasionally stop the
Polisher, disconnect it from its electrical
outlet, remove the worn sandpaper and
replace with new sandpaper.
When the sanding process is complete,
9.
turn the Power Switch (11) to its “OFF”
position. Then unplug the Power Cord
(5). (See Figure C.)