Bissell 1725 - Manual (Page 6)

How to deep clean carpet or upholstery
Getting ready
1. Remove Vacuum flex Hose completely from On Board
Hose Storage.
2. Attach 4" Tool, 6” Tool* UirboBrush* or Crevice Tool* to
Grip Trigger Unit by pressing Tool onto Grip/Trigger Unit
firmly, until button snaps into hole. Make certain
Tool is securely attached.
3. Unwrap Power Cord completely from On Board
Cord Storage and plug into 120 Volt, 60 Hz grounded
outlet as described in Important Safety Instructions, page 2.
4. If cleaner starts when first plugged in, switch cleaner off
until ready for use.
5. Move Power switch to ON position.
6. If your Little Green has a built-in heater, refer to instructions
on page 5.
7. Press and hold Spray Trigger on Grip/Trigger unit. Spray
will start in a few seconds.
8. Raise the tool slightly to check for spray. If spray does not
start, press firmly on the front of the Solution Tank while
depressing Spray Trigger.
*OptionaJ on some Little Green models. To order optionai parts not originally
included in your Little Green mode!, call BISSELL Consumer Sendees at
the telephone number listed on page 9-
Pre-treating
1. Pre-treat stained or highly soiled areas: Hold the tool
4”- 6” above carpet or upholstery, and pull trigger to
spray cleaning solution.
2. "Wait 3-5 minutes before cleaning.
Deep cleaning
1. Place the tool directly on soiled surface at arms length.
Apply downward pressure on the tool and pull toward you,
while pulling trigger to spray cleaning solution.
NOTE: If using the TurboBrush, llie switch should be in the "BRUSH”
position. 'Hiis activaies die brush only.
2. Repeat, keeping the tool firmly against the surface.
Continue until no more dirt can be removed.
Do not overwet.
NOTE: If using the TurboBrush, move the switch to the “SUCTION”
position. This activates the suction to remove the dirt and cleaning
solution. .Move the switch back to the “BRliSH" position for additional
brushing action.
Do not overwet.
3- Release spray trigger. Vacuum area until no more
cleaning solution can he removed.
NOTE: if using the 'AirboBrush. move the switch to the "SUCTION”
position, This activates tlic suction to remore the dirt and cleaning solution.
4. If the tool stops spraying, turn Off Power Switch and check
cleaning solution level. Refill if needed. Never mn dry.
A WARNING;
Be sure to unplug the
cord before attaching
the ThrboBnish."'