beautypg.com

Zippy R2W-6500P User Manual

Page 14

background image

TTL signal :

Sink current max. 5mA

Source current max. 50uA

Low Active --- Defective

High --- Normal

1.11 TROUBLE SHOOTING

If you have followed these directions correctly, there should be no problem
occurred. Some common symptoms are: the system doesn’t work, buzzer sounds,
work for a very short period, etc., please try the following steps to verify and
correct it:

1. Check all the connections (correct pinouts, loose connections, wrong direction,

etc).

2. Check for short-circuits or defective peripherals by unhooking each peripheral

once at a time. When the systems functions again, you have solved the
problem.

3. Once you hear the buzzer sound or see the LED with RED light, please be

aware of :


a. If the load is under the minimum / over the maximum load of each channel

(please refer the Sec. 1.7 specification)?

b. If each power cord been well plugged into the inlet?

Suppose the above conditions happen, please unplug the power cords, wait for 2
~ 3 minutes for releasing the protection state, then test it again.

c. If buzzer still sounds or the LED shows power module is defective, please

locate the defective power module, perform hot-swap procedure (please refer
to the Sec. 1.9 Hot-swap procedures), sent the defective power module to your
vendor for RMA operation.


d. If you can not fix the problem, please contact with your vendor for supporting.

13

This manual is related to the following products: