Zippy M1W4-6950P - Manual (Page 26)

INPUT CHARACTERISTICS: M2W-6460P
l
VOLTAGE: 100~240VAC FULL RANGE
l
FREQUENCY:47~63HZ
l
INPUT CURRENT: 4A ( RMS ) FOR 230VAC
l
8A ( RMS ) FOR 115VAC
l
INRUSH CURRENT : 60 A MAX.FOR 115 VAC PER MODULE
l
80 A MAX. FOR 230 VAC PER MODULE
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
MIN. [A] MAX. [A] LOAD LINE
+5V 3.5 30 ± 5% ± 1% 70mV
-5V 0.05 0.7 ± 5/-10% ± 1% 120mV
+12V 2 32 +6% ± 1% 120mV
-12V 0.05 0.7 +5/-10% ± 1% 120mV
+3.3V 1 24 ± 5% ± 1% 70mV
+5VSB 0.1 2.0 ± 5/-6% ± 1% 70mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. [P-P]
REMARKS: 1.TOTAL CURRENT OF +5V AND +3.3V NOT EXCEED 40A
2.TOTAL OUTPUT POWER NOT EXCEED 460W
SPECIFICATION:
l
TEMPERATURE RANGE: OPERATING 0 --- 40 ,STORAGE -20 --- 70
l
HOLD UP TIME: 1.6 ms MINIMUM AT FULL LOAD & 90VAC INPUT VOLTAGE
l
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 MINUTE
INPUT TO FRAME GROUND 3000 VAC FOR 1 MINUTE
l
EFFICIENCY: 65% TYPICAL, AT FULL LOAD
l
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
l
OVER LOAD PROTECTION: 110~180% MAX
.
OVER VOLTAGE PROTECTION: +5V à 5.7V ~ 6.5V, +3.3V à3.9V~4.7V,+12V à 13.3V ~ 14.3V
.
OVER CURRENT PROTECTION
l
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B
l
SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
l
REMOTE ON / OFF CONTROL
l
FAULTY ALARM METHODS:LED, BUZZER, TTL SIGNAL
l
MEET IEC-1000-3-2 CLASS D ( ACTIVE PFC)
l
HOT-SWAPPABLE/HOT PLUGGABLE REDUNDANCY FUNCTION
l
REMOTE SENSING DESIGN
l
ISOLATION:BUILT-IN THE POWER MODULE
l
COOLING: TWO 38x38x28mm DC FANS