beautypg.com

Zippy M1G3-6930P User Manual

Page 9

background image

1.8 Hot-swap procedures

Please refer to the following when one power module is found defective.

(1) Locate the defective power module by examining the individual LED (if LED is

without light, it indicates the power module is defective).

WARNING:

Please perform the BELOW step carefully; otherwise, it may cause shut down of the

whole system.

(2) Turn off

WARNING:

Please do not remove the defective power module until you have worn gloves to keep

from been burned. This is due to the cover of the power module is used as heat sink

for cooling. Usually, its temperature is around 50-60 degree Celsius under full load

condition.

(3) Remove the defective power module by puling out method.

WATNING:

Please put aside the power module to wait for cooling down. Keep other people from

toughing it until it is cooled.

(4) Replace a new / GOOD power module, insert the power module into the power

system till to the end.

(5) Turn on the new power module.

(6) Check the LED of the power module light GREEN.

(7) Check the LED which indicates the total power system status, that SHOULD be

from blink/RED to GREEN.

(8) If you want to test this new power module and simulate the defective situation,

please refer to Section 1.7 Installation & Testing Section.

This manual is related to the following products: