Zippy DGIH3-6650F - Manual (Page 6)

INPUT CHARACTERISTICS: DGIH4-6950F
l
VOLTAGE: DC -36 V ~ -72 V
l
INPUT CURRENT: 40A (RMS), FOR –48VDC
l
INRUSH CURRENT : LESS THAN 10A.FOR EACH POWER UNIT
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
MIN.[A] MAX.[A] PEAK(A) LOAD LINE
+5V 3.0 90 ± 5%
± 50mV
50mV
-5V 0.1 1.2 ± 10%
± 50mV
150mV
+12V 2 60 ± 5%
± 120mV
120mV
-12V 0.1 2 ± 10%
± 120mV
150mV
+3.3V 1.0 54 ± 5%
± 50mV
50mV
+5VSB 0.1 5 ± 5%
± 50mV
50mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. [P-P]
REMARKS: 1. THE OUTPUT POWER OF 5V & 3.3V MAX:95A
2.+5V, +3.3V AND +12V TOTAL OUTPUT MAX:900W
l
TEMPERATURE RANGE: OPERATING: -10 --- 40 (-36V ~-72VDC INPUT)
-10 --- 50 (-46V~-72VDC INPUT)
l
STORAGE: -20 --- 80
l
HOLD UP TIME: 1.6 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
l
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
l
EFFICIENCY: 65% TYPICAL AT –48VDC FULL LOAD
l
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms
l
OVER POWER PROTECTION: 110% ~ 160%
OVER VOLTAGE PROTECTION: +5V à 5.7V ~ 6.7V, 3.3V à 3.7V ~ 4.7V
+12V à 13.0V ~ 15.0V
OVER CURRENT PROTECTION: 110% ~ 150%
l
SHORT CIRCUIT PROTECTION: +5V, +12V, +3.3V, AUTO RECOVERED: 5VSB, -5V, -12V
l
EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
l
SAFETY: UL 60950, CSA 22.2 NO/ 60950, TÜV CCC GB4943-1995, GB9254-1998,
GB17625.1-1998
l
REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE /
ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
l
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
l
FAULTY ALARM METHODS : LED, BUZZER, TTL SIGNAL
l
3+1,HOT-SWAPPABLE / HOT-PLUGGABLE REDUNDANCY FUNCTION
l
BALANCE LOAD SHARING DESIGN ON 5/12/3.3V CHANNEL
l
REMOTE SENSING DESIGN
l
ISOLATION: BUILT-IN THE POWER MODULE
l
DIMENSION: 41(H) X 383(W) X 330 (D) mm