Workrite Fundamentals EX Electric Assembly Instructions for 2-leg Workcenters 30”–48” Wide - Manual (Page 6)

6 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Fundamentals Workcenters - Assembly Instructions for 2-leg Tables, 30”–48” Wide
Attach Switch
If you have a Workrite worksurface:
Position the switch over the pilot holes near front
edge of worksurface.
If you do not have a Workrite worksurface:
For non-Workrite worksurfaces, align Switch (N)
so that outermost edge of switch is flush with
edge of worksurface. Pre-drill screw pilot holes
into underside of worksurface with 3 ⁄
32
” drill bit.
You may wish to mark your drill bit so you do not
drill any more than ¾” deep and damage your
worksurface top.
Do not drill all the way through
worksurface!
Attach Switch (N) to underside of worksurface
using the smaller (#8 × ⅝”) Pan Head Screws
(K). You may have purchased the Standard
Control which attaches in the same fashion.
b
b
6
a
Attach Feet (sold separately) & Slides
Attach Feet (G) to bottom of legs with Flat Head
Cap Screws (I), using Allen Wrench (K) and tighten
securely. Be sure the longer end of the foot goes
towards the front of the table.
You may have purchased the Styled Feet, that attach
in the same fashion.
Attach Feet Glides (H) to bottom of feet. Do not
screw in all the way to allow for leveling in step 10
5
front
N
K
H
a
b
G
G