Workrite Sonoma Series PREMIUM User Guide - Manual (Page 5)

Drive to a stored position:
Press memory button 1, 2 or 3. The display will flash “GO1”,
“GO2” or “GO3” for 3 seconds. Within the 3 seconds press
UP or DOWN button and keep it pressed until the table stops in
the stored memory position. While running to a stored position,
the display will read GO1, GO2 or GO3 until it reaches the posi-
tion. The height will then be shown. Releasing the UP or DOWN
button will abort the memory drive.
Adjust the display to show the
correct height:
It may be necessary to adjust the display upon initial setup. The
default setting of the display is set to show 68 cm or 27 inches as
the lowest height of the table. The low height will vary depending
on flooring surface and height of leveling guides. To obtain accu-
rate height display, lower table to its lowest position and measure
from the floor to the top of the worksurface. Change the display
readout as follows: while pressing and holding the “S” button,
hit the UP or DOWN button until the display shows the correct
height. The display moves in 1/2 inch/centimeter increments.
Initialization procedure:
If the the legs do not move when pressing the UP or DOWN
button, it may be necessary to re-initialize the system. This may
happen when the DOWN button is pressed while the table
is in its lowest position. It will move down slightly and will not
respond to the UP or DOWN button.
To initialize, press and hold the down button for 2 seconds.
The table will move up, down and then up very slightly.
When movement stops, the system has been initialized.
If the down button is released before the sequence is complete,
then the initialization is interrupted and must be started again
from the beginning.