Workrite Sonoma Series BASIC - Manual (Page 4)

Sonoma Series
™
BASIC Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com Page 3
ASSEMBLY INSTRUCTIONS
Slide Crossbar onto Crossbar Brackets and attach
with two machine screws to each bracket.
If you are assembling a three leg table, note that the middle
leg is oriented at a 45° angle. The side with the double
flange Crossbar Bracket faces the front edge of the table.
It is easiest to adjust the height while the table
is upside down. Pull the Ring Pins from each leg
and raise or lower legs to their desired height and
re-insert pins.
Flip table over and adjust Leveling Glides if
required so that table is steady and does not rock.
Attach the Top Brackets to the underside of the
worksurface with the wood screws provided.
Use the locating holes.
STEP 5
STEP 7 STEP 8
STEP 6