Crimestopper SV-8400.RM - Manual

SV-8400.RM
Installation Instruction
Crimestopper Security Products Inc.
1770 So. Tapo Street
Simi Valley, CA 93063
(800) 998-6880
www.crimestopper.com
©2008 Crimestopper Security Products
CONNECTIONS AND OPERATION
1. CONNECT THE RED WIRE TO +12V DC, PLEASE NOTE THE “RED
POWER WIRE” HAS TO CONNECT TO A POSITIVE 12 VOLT
CONSTANT POWER SOURCE OF POWER AND THE “BLACK WIRE
GROUND WIRE” SHOULD BE CONNECTED TO A GOOD CHASSIS
GROUND LOCATION OR THE NEGATIVE TERMINAL OF THE
BATTERY.
2. MOVE THE” MAIN POWER SWITCH” ON SIDE OF MONITOR TO
THE ON POSITION. THE MONITOR WILL AUTOMATICALLY TURN
ON AND OFF WHEN MONITOR IS DROPPED DOWN FROM LOCKED
POSITION.
3. CAMERA INPUT SIGNAL COMES FROM REAR VIEW CAMERA AND
PLUGS INTO “CAMERA INPUT (RED) RCA JACK.
4. OPTIONAL VIDEO SIGNAL COMES FROM VCD, VCR, OR DVD AND
PLUGS INTO “VIDEO INPUT (YELLOW) RCA JACK.
5. BACKUP CAMERA CONTROL WIRE (BLUE) CONNECTS TO +12
VOLTS DC OF CAR REVERSE LIGHT WIRE, WHEN THE GEAR IS IN
REVERSE, THE MONITOR IMAGE WILL AUTOMATICALLY SWITCH
TO THE BACK UP CAMERA.
6. USE “NOR/REV SELECTOR SWITCH” TO CHOOSE THE MIRROR
OR NON-MIRROR IMAGE.
7. MOVE THE “DIMMER SWITCH” TO SELECT BRIGHTNESS OF
IMAGE .