Vermont Casting BFC36 - Manual (Page 22)

22
BFC36 Balance Flue Heat-Circulating Fireplace
7412647
Chimney Components
Component Description Model Number
Chimney Support Used to support chimney for each of TCS8A
30’ vertical height and 6’ of angled chimney run (8” flue)
Firestop Required at each floor level and attic on FS2A (8” straight flue)
multi-story installation FS6A (8” 30° inclined flue)
Attic Insulation Shield Required in Canada FS2100HT
Traditional Top Housing Top housing of simulated brick pattern T20B
available in red, tan or white. Appropriate (single flue)
adapter is required (8CA). Flashing included. TL20B
(extra tall single flue)
Housing Extension Extends Traditional Top Housing on 202036
steep pitched roofs (single flue)
Contemporary Chase Top Used to terminate chimney at the top of a
Termination chase. Flashing is not included. TT200C
Adapter Kit (TT8CB) is required.
Chase Top Housing Used with chase terminations to prevent rain entry. FL88
(8” flue)
Contemporary Flashing 8-6-12 with 8” flue
Required for Contemporary Round Top 0 to 6/12 pitch
termination to prevent rain entry. 8-12-12 with 8” flue
(6/12 to 12/12 pitch)
Chimney Sections 8” flue
81 (1’ long)
Used to build chimney systems. 818 (1¹⁄₂’ long)
83 (3’ long)
84 (4’ long)
Chimney Elbows Used to develop offset chimney systems.
Only 30° elbows are available. (Elbows 830A-2
packed 2 per carton - upper and lower (8” 30° flue)
elbow set.)
Round Top Termination Used to terminate chimney on the roof. RT8C
Flashing not included. (8” flue)
Extended Round Top Chase Used to terminate chimney at the top of a RT8CL
Termination chase. Adapter Kit included. Flashing not (8” flue)
included.
Adapter Kit Required to connect triple-wall chimney 8CA
with Traditional Top Housing (T20B or TL20B) (8” flue)
Adapter Kit Required to unite chimney with TT8CB
Contemporary Chase Top. (TT200C)