Universal Remote Control (URS) MRZ-260 - Manual (Page 5)

Page 2
MRZ-260 B
ASE
S
TATION
Features and Benefits
Interference Rejection and Extended Range via Spread Spectrum
The MRZ-260 receives RF (radio frequency) signals via it’s integrat-
ed RF receiver and antenna. A compatible RF remote such as the
MX-880Z can be used with the MRZ-260 base station.
Two Fixed IR Outputs one with RFTX URC Lighting Control
The MRZ-260 is equipped with two fixed IR line outputs with standard
3.5 mm jacks for standard and sleeved IR emitter/flashers. One Fixed
IR Output has a dual role for URC Lighting Control via the RFTX
transmitter
Two Variable IR Outputs Match Rear Panel IR Inputs
The MRZ-260 is equipped with two adjustable IR line outputs. Each
output can be individually matched to rear panel IR inputs on any
component that is designed to be operated by a standard IR repeater.
The outputs utilize a 3.5mm jack and are compatible with standard IR
emitter/flashers as well.
No Limit Equipment Locations With Identical Components
Each MX-880Z remote is “addressable.” They can be programmed to
specifically control components in a particular room by installing an
MRZ-260 base station at each location. In operation it’s simple: when
you select a device located in the Den, the MX-880Z remote only
sends commands to the Den. When you select a device located in
the Family Room, the MX-880Z remote only sends commands to it.
A Single MRZ-260 Can Control an Array of Identical Components
or Individual Zones of a Multi Zone Preamp/Matrix Switcher
Each MRZ-260 has four “addressable” IR Line Outputs. For example,
you can control up to four identical TV’s with one MRZ-260 or route
volume commands for a specific zone to a particular zone IR input on
a multi-zone preamp. If you have more than four identical compo-
nents or zones, there is no limit on how many MRZ-260s can be
installed to control them (thus allowing an unlimited amount of identi-
cal components or individual zones in one house).
Parts Guide
The MRZ-260 RF Base Station includes:
1 - MRZ-260 Base Station
1 - Mounting Plate for wall mounting
the MRZ-260
4 - Screws for wall mounting
1 - 9V-300mA Power Supply
12 - Labels for IR Line Outputs
4 - Visible Flashers with 10 foot plug in
cables including 1 pink sleeved
emitter for the RFTX-1 port
4 - Extra self adhesive pads for
Emitters
1 - Screwdriver for Variable Outputs