ThingMagic Autonomous Configuration Tool - Manual (Page 18)

Configure
Autonomous Configuration Tool v1.0 User Guide 18
Save Profile
Once connected to a reader the desired autonomous configuration of the reader,
including read settings, performance settings and display settings can be saved to a
URAC (URA Config) file by following these simple steps:
1. Click “Save”
2. File manager pops up with the default filename field populated with [reader
type]_[readername].urac. This maybe changed as desired.
3. Click “Save” in the file manager to save to the specified file.
Load Profile
If you want to load a previously saved profile onto another reader you must first connect to
the reader then load the settings into ACT then apply them to the reader:
1. Once connected to the reader click “Load”.
2. Select desired *.urac file and “Open”.
3. The full saved profile and display options are loaded.
4. Click “Apply” to store the loaded settings onto the connected read.
Firmware Update
The section provides a way to upgrade the firmware of the connected reader.
To upgrade:
1. Click Choose Firmware and navigate to the filesystem location where the
firmware file is located.
2. Select the firmware file and click Open.
3. Click Update.
4. Upon completion the Status message will change to indicate it has completed.
Note
The latest firmware is always available on http://rfid.thingmagic.com/devkit. It
requires a password which can be obtained from ThingMagic Support if you have
an active support contract.