Thetford Nelson - Manual (Page 5)

INTRODUCTION
In your own interest of safety, gas appliances should be installed by competent persons.
Failure to install the appliance correctly could invalidate any warranty or liability claims.
This appliance shall be installed in accordance with the manufacturers installation
instructions, local gas fitting regulations, municipal building codes, AG5601 and any other
relevant statutory regulations.
Data Label
The data label is located on the bottom right hand side panel near the front of the cooker.
A duplicate data label is supplied to adhere to an accessible area next to the
appliance.Ensure that the gas supply is Propane. This appliance is designed for use with
Propane Gas and should not be converted for use with any other gas.
Ventilation
The use of a gas cooking appliance results in a production of heat and moisture in a room
in which it is installed. Ensure that the kitchen is well ventilated and in accordance with
AG601 Installation Code. In general, the appliance should have adequate ventilation for
complete combustion of gas, proper flueing and to maintain temperature of immediate
surroundings within safe limits.
Location
Chose a location free of draughts and open doors and clear of combustible materials or
other fire hazards. The location should ensure convenience of operation and service. Any
adjoining wall surface situated within 200mm from the edge of any hob burner must be a
suitable non-combustible material for a height of 150mm for the entire length of the
hotplate.
Any combustible construction above the hotplate must be at least 600mm above the top of
the burner and no construction shall be within 450mm above the top of the burner. All
combustible materials such as curtains or shelves should be kept well clear of the cooker.
5