Thetford NRF60 - Manual (Page 5)

5
Set theTemperature
The Temperature Setting Panel (see Art02216) has two modes of operation, the Factory
setting mode and the Memory setting mode. In both modes, you may set the controls to
maintain the temperature, in the center part of the refrigerator/freezer, between -13°F -(25°C)
and 108°F (42°C).
Push and hold both the up arrow and
the “set” button for a few seconds to
change the temperature display back
and forth between Fahrenheit (°F) and
Celsius (°C).
Factory setting mode
Each time that you turn the refrigerator/freezer “ON”, the temperature setting is 5°F
(-15°C). If you wish to change the temperature setting:
- Press and hold the “set” button for 2 seconds.
- Press and hold either the up or down arrow until the desired temperature appears in
the window.
- Release the up or down arrow to select the temperature setting.
Memory setting mode
The first time that you turn the refrigerator/freezer “ON”, the temperature setting is 5°F
(-15°C). If you wish to change the temperature setting:
- Press and hold the “set” button for 2 seconds.
- Press and hold either the up or down arrow until the desired temperature appears in
the window.
- Release the up or down arrow to select the temperature setting.
- Press and hold the “set” button for 2 seconds.
- The next time that you turn the refrigerator/freezer “ON”, the temperature setting will
be at this same setting, unless you choose to change it.
NOTE: The refrigerator/freezer has a delay protection feature to avoid overloading the
vehicle at start-up. The temperature shown in the window should change within the
first 15 minutes of operation.
When not using the refrigerator/freezer, remove the DC power cord from the cigarette lighter
to prevent discharge of the battery.
Art02216
▲ ▼ Set
Power
Error
° F
° C