Combi 7735 - Manual (Page 6)

Removing/Attaching the Seat Cushion
Removing
1. Unbuckle the 5-point harness and pull all the straps
through the seat cushion.
2. Grasp the seat cushion at the top and unfasten from the
velcro.
Attaching
1. Pass the 5-point harness straps through the appropriate
locations in the seat cushion.
2. Fasten the velcro.
CAUTION
If seat cushion is ripped or torn,
do not use. Do not use the stroller
without the seat cushion.
-6 -
Folding the Stroller
1. Raise the backrest to the upright position.
2. Fold the canopy by lifting the canopy levers.
3. Lift up and hold the Folding Levers located on each side
near the top of the handle as shown in the Figure (A).
Then, tilt the stroller backward until it starts to fold.
4. Grasp the guardrail and handle in opposite hands and
pull together.
5. Engage the folding latch on the side of the stroller as
shown in the Figure (B).
6. Rotate handle to fold position as shown in the
Figure (C).
Folding Levers are
located below the
handle adjuster
buttons on each side
of the handle.
Figure A
Figure B
Figure C
Folding
Latch