Snow Joe LJ601E-RM Logger Joe 15-Amp 5 Ton Electric Log Splitter - Manual (Page 3)

3
or connectors described in this manual.
13. Avoid Unintentional Starting – Don’t carry plugged-in
appliance with finger on switch. Be sure switch is off
when plugging in.
14. Don’t Abuse Cord – Never carry appliance by cord or
yank it to disconnect from receptacle. Keep cord from
heat, oil, and sharp edges.
15. Don’t Force Appliance – It will do the job better and
with less likelihood of a risk of injury at the rate for
which it was designed.
16. Don’t Overreach – Keep proper footing and balance at
all times.
17. Stay Alert – Watch what you are doing. Use common
sense. Do not operate appliance when you are tired.
18. Disconnect Appliance – Disconnect the appliance from
the power supply when not in use, before servicing,
and when changing accessories.
19. Store Idle Appliances Indoors – When not in use,
appliances should be stored indoors in dry, and high or
locked-up place – out of reach of children.
20. Maintain Appliance With Care – Keep cutting edge
sharp and clean for best performance and to reduce
the risk of injury. Follow instructions for lubricating
and changing accessories. Inspect extension cords
periodically and replace if damaged, have it repaired by
an authorized service facility. Keep handles dry, clean,
and free from oil and grease.
21. Check Damaged Parts – Before further use of the
appliance, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced by
an authorized service center unless indicated elsewhere
in this manual.
OPERATION
Operator Requirements
1. Only one person shall operate the log splitter. All other
individuals and animals shall maintain a safe distance
during operation (see safety warning in Preparation).
2. Always operate the machine in a standing position and
in a location that is not in the path of projected debris.
The location of the machine should provide safe footing
and balance for the operator.
3. Do not operate the machine while under the influence
of alcohol, drugs or physically, mentally fatigued.
Always be alert and watch what you are doing!
4. Contact with the moving parts can amputate body parts.
Do not put any part of your body near moving parts.
Workload Requirements
1. Never exceed the operating capacity of the log splitter.
2. Always split the log in the direction of the grain. Do not
place a log across the log splitter.
3. Never spilt more than one log at a time.
4. Do not load a log when the ram is moving.
Log Splitting
1. Remove any keys and adjusting wrenches before
turning the machine ON.
2. Do not use accessories or attachments that are not
recommended in this manual.
3. Place the log on the log retention brackets. Do not hold
or secure the log with your hands.
4. Do not split wood that takes more than 5 seconds to
split. Doing so will apply excessive pressure on the ram
cylinder and damage the machine.
5. Do not push/force the log onto blade. Always let the
blade initiate splitting the log.
6. If the log moves during operation, stop and reset.
7. If a log is jammed do not request assistance of
a second person. Ensure the machine power is
disconnected and built up pressure released before
attempting to release log.
8. Ensure the machine is turned OFF when not in use. If
the machine is left unattended then disconnect power
to the machine.
MAINTENANCE AND STORAGE
1. Maintain or replace safety and instruction labels. Ensure
safety guards are in place.
2. Disconnect the power and ensure built up pressure has
been released from the tool before cleaning, repairing,
or inspecting the log splitter.
3. For best operation keep the blade sharp, moving parts
lubricated and the machine cleaned.
4. Always check for damaged or worn parts, alignment of
moving parts, and tightness of bolts and screws before
each use.
5. Replace oil as specified in the Maintenance section.
Follow all local regulations and laws concerning
disposal of waste oil.
6. Qualified mechanics and electricians must carry out
repairs.
7. When not in use, always store the machine in a secure
location that children cannot access. Store the machine
in a dry environment. The machine can be transported
or stored in the ambient temperature between 25ºC –
55ºC (77ºF – 131ºF).