Snow Joe 324E Plus 11-Inch 10-Amp Electric Snow Shovel with Light - Manual (Page 9)

9
4. Remove the old paddle auger from the housing (Fig. 11).
5. To install the new paddle auger, place the washer (A) back
onto the bolt (removed in step 1) and insert the bolt so that
it protrudes slightly into the housing of the unit. Thread the
nut and then the other washer (B) onto the bolt. Fit the new
auger onto the end of bolt and tighten the bolt (Fig. 12).
6. Reinstall the big pulley plate (Fig. 10) and align it with the
other end of the auger. After fitting the auger into position,
secure the big pulley plate with the three (3) screws
(Fig. 13).
NOTE: The housing will flex to allow for installation of the
new paddle auger.
7. Place the tensioner back into position. Rotate the auger to
ensure that the belt and auger move freely, then reinstall
the cover by securing it with the seven (7) screws
(Figs. 14 & 15).
m
WARNING!
Do not power the unit until the cover guard
is securely in place to prevent damage or injury.
Replacing the Belt
m
WARNING! Disconnect the power from the electric
snow shovel before performing this task.
1. Disassemble the left side cover by removing the
seven (7) screws (Fig. 9).
2. Remove the tensioner (Fig. 16).
3. Unscrew the three (3) screws from the big pulley plate and
the four (4) screws from the small pulley plate (Fig.16).
4. Replace the worn belt with a new belt.
Fig. 11
Fig. 12
Washer (A)
Nut
Washer (B)
Bolt
Fig. 13
Fig. 14
Tensioner
Big pulley plate
Fig. 15