Snow Joe SJ624E Ultra 21-Inch 14-Amp Electric Snow Thrower - Manual (Page 9)

8
Securing the Extension Cord
1. For safe and efficient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart on page 2.
2. Push the loop of the extension cord through the slot on
the cord lock from the opposite side of the restraint hook.
Position the loop over the hook and pull the cable back
through the slot (Fig. 14).
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 15).
4. Note that the snow thrower has a polarized male plug –
one prong in the plug is slightly longer and wider than the
other (Fig. 16). The extension cord female end should be
likewise polarized so that the extension cord fits snugly
into the appliance plug.
Powering On and Off
m
WARNING! The auger starts rotating immediately
after the snow thrower is switched on. Keep hands
and feet away from the auger.
1. To switch the snow thrower ON, press the safety switch
button, then squeeze the switch bar lever (Fig. 17).
2. Once the snow thrower starts, release the safety switch
button and proceed with operation.
3. To power OFF, release the switch bar lever.
Fig. 14
Fig. 15
Fig. 16
m
WARNING
m
Damaged electrical cords present risk of fire,
electrical shock and serious bodily injury.
Before operating the snow thrower, carefully examine
the electrical cord. If the cord is damaged, do not use
the snow thrower. Replace or repair the damaged cord
immediately. If you need assistance, contact an
authorized Snow Joe ® + Sun Joe ® service center.
Fig. 17
Safety lock
button
Switch bar
lever