Snow Joe SWJ701E Saw Joe 18-Inch 14-Amp Electric Chain Saw - Manual (Page 3)

3
• Skin contact with the oil.
• Loss of hearing, if required ear protection is not used during
work.
• There may be health risks caused by breathing in the
wood dust, especially during the sawing of oak, beech and
medium density fireboard.
Extension Cords
• Make sure your extension cord is in good condition. When
using an extension cord, make sure to use one heavy
enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage, resulting
in loss of power and overheating. Table 1 shows the
correct size of cord to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
• Ground Fault Circuit Interrupter (GFCI) protection should
be provided on the circuits or outlets to be used for this
electric chain saw. Receptacles are available having built-
in GFCI protection and may be used for this measure of
safety.
• Use only UL listed extension cords. Inspect extension
cord before use and never use damaged or altered
extension cords. Follow extension cord manufacturer
safety instructions.
• To reduce the risk of the appliance cord disconnecting
from the extension cord during operation, use the
plug-receptacle retaining straps provided or make a knot
with the two cords as shown in Table 2.
• Do not abuse the cord. Never use the cord to carry
the tools or pull the plug from the outlet.
• Keep cord away from heat, oil, sharp edges, or moving
parts. Replace damaged cords immediately. Damaged
cords increase the risk of electrical shock.
Table 1. Minimum Recommended Extension Cord Gauge
(AWG) Chart
Table 2. Method of Securing Extension Cord
General Safety Instructions
for Chain Saw User
• It is important that this tool be protected by the use of a
residual current device.
• Cluttered areas and benches can cause accidents.
• Read the following safety instruction manual before
attempting to operate this device. Be aware of the tool's
operation range and limitations as well as its dangers.
• When not in use, power tools must be stored in a dry place
and locked up securely, out of the reach of children and
unauthorized persons.
• When not in use, when transporting between work
locations, or when carrying out any form of maintenance,
the tool must be disconnected from the mains power and
the saw guard must be fitted.
• Never allow the chain saw near your body or your clothing.
• When switching on the chain saw, make sure the chain is
not touching anything.
• Do not start up or use the chain saw near people,animals,
or obstructions.
• During operation, keep the tool a safe distance (at least
10 m) away from the above hazards.
• Always use both hands to operate the chain saw; place the
right hand on the rear handle and the left hand on the front
handle (see page 6 – Know Your Electric Chain Saw).
m
WARNING! Never attempt to operate ‘left-handed’ as
serious personal injury may result.
• Stand in a safe and comfortable position with both feet
firmly planted on a level and secure surface.
• Never carry the chain saw by the cable.
• Keep the cable away from heat sources, oils, or sharp
edges.
25
18
18
14
14
50
16
16
14
12
100
16
14
14
150
14
12
12
Volts
120V
1 – 5
6 – 10
10 – 12
12 – 16
Total length of cord in feet
AWG
(Extension Cord Gauge)
Not Recommended
Ampere Rating
(B) Connect plug and receptacle
Cord set Appliance cord
(A) Tie cord as shown