Snow Joe TRJ609E Trimmer Joe 3-Amp 9.45-Inch Electric Grass Trimmer - Manual (Page 8)

8
3. Do not overload your trimmer; instead, take small “bites”
of grass, working from the top to the bottom.This will
keep the machine operating at high speed and will greatly
improve its cutting efficiency (Fig. 9).
Starting for the first time and operation
1. You will need to exert a certain force to pull out the line
when the trimmer is used for the first time. To do so,
depress the push button and pull out the line to the edge
of the guard hood (Fig. 10).
2. The line will be cut to the correct length once the cutting
head starts. A short, worn nylon line will result in poor
cutting performance.
3. To restore the correct line length, press the trimmer against
the ground while the cutting head is running (Fig. 11).
4. The length of the line will then adjust automatically
(Fig. 11).
Replacing the spool
m
WARNING! Unplug the mains supply cable before
changing the trimmer line.
NOTE: A dual-line factory wound spool (model TRJ609ERS) is
available for easy spool replacement on the TRJ609E electric
grass trimmer. Visit snowjoe.com to purchase this accessory
online.
1. Disconnect the mains supply cable.
2. Press together both locking device tabs on the spool cover
and remove the cover (Figs. 12-13).
3. Remove the spool from the spool cover (Fig. 14).
4. Remove the spring and clean out any dirt or grass residue.
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Locking devices
Spool cover
Spool