Snow Joe SPX1000-RM Pressure Joe 1450 PSI 1.45 GPM 11.5-Amp Electric Pressure Washer - Manual (Page 8)

• Store the machine and accessories in a room that does not
reach freezing temperatures.
• Do not store near a furnace or other sources of heat as it
may dry out the pump seals.
• Operate the washer with non-corrosive/non-toxic
antifreeze before storing for the winter.
m
WARNING! Before reusing, completely flush the unit
out with plain water. Antifreeze can damage paintwork so you
must ensure there is no antifreeze left in the system before
using it again.
Maintenance
m
CAUTION! Before working on the washer, disconnect
the plug from the power supply socket.
• To ensure good performance, check and clean the water
inlet filter (Fig. 12). Remove filter and rinse with warm
water to prevent any foreign matter from clogging the
pump (Fig. 13).
• Clean the nozzle with the needle clean out tool provided.
Remove the spray wand from the gun; remove any dirt from
the nozzle hole (Fig. 14) and rinse.
Circuit Diagram
A circuit diagram for the pressure washer is provided below for
your reference (Fig. 15).
Disposal
Recycling the washer
• Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities.
• Contact your local government agency for information
regarding the collection systems available.
• If electrical appliances are disposed of in landfills
or dumps, hazardous substances can leak into the
groundwater and get into the food chain, damaging your
health and well-being.
• When replacing old appliances with new ones, the retailer
is legally obligated to take back your old appliance for
disposal at least free of charge.
Fig. 12
(REAR)
Water inlet filter
Garden hose adaptor
Fig. 13
Inlet filter
Fig. 14
Needle clean out tool
!
Micro-switch
Motor
Capacitor
On/off switch
Power cord
Fig. 15
8