Snow Joe TJ600E Tiller Joe 6.5 AMP Electric Garden Tiller/Cultivator - Manual (Page 6)

6
Assembly
CAUTION
m m
Inspect wiring, which, if damaged during shipping,may
cause serious bodily injury during equipment use. If any
damage is seen or suspected, do not assemble. Instead,
contact Snow Joe Customer Service for assistance.
Handle with care during assembly so that electrical wiring
does not become damaged.
Note: Reference to right or left side of the tiller is determined
from behind the unit in the operating position. The “Operator’s
position” is defined as standing directly behind the tiller.
Follow these steps to assemble:
1. Remove tiller from the carton.
2. Slide the Right-hand Grip (A) and Left-hand Grip (D) into
the Plastic Cross Plate (I). Secure the Plastic Cross Plate
to the Left and Right-hand Grips with the included screws.
(See Fig 2-1, 2-2, 2-3)
Note: Use a phillips-head screwdriver. Aligning the holes
may be difficult. We recommend fastening one hand grip
at a time to the Plastic Cross Plate.
Figure 2-2
Front View
Figure 2-3
Back View
A
D
I
Screws
Figure 2-1
Front View
Align the bottom of beam with the white line on the side of upper
handle before tightening 2 screws.