Battery pack operation, Charger operation m, Battery charge level indicator – Snow Joe iON16LM 40-Volt Cordless 16-Inch Lawn Mower w/ Brushless Motor User Manual
Page 10: When to charge the ecosharp, Ibat40 lithium-ion battery, Installing and charging the battery
10
Battery Pack Operation
The equipment is fitted with a lithium-ion battery. The battery
pack is completely closed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
Immediately after using the battery pack, the charge level
button may display a lower charge than it will if checked a few
minutes later. The battery cells “recover” some of their charge
after resting.
Charger Operation
m
WARNING!
Charge only EcoSharp
™
iBAT40 lithium-ion
battery packs in compatible EcoSharp
™
iCHRG40 lithium-ion
battery chargers. Other types of batteries may cause personal
injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the EcoSharp
™
iBAT40
Lithium-Ion Battery
NOTE: The EcoSharp
™
iBAT40 lithium-ion battery packs do
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery pack before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your EcoSharp
™
iBAT40 lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Installing and Charging the Battery
1. Open the battery cover on the lawn mower by depressing
the locking button found on the outside of the battery
compartment (Fig. 6).
2. Pull the push lock button on the battery to pull the battery
pack up and out of the equipment (Fig. 7).
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators
Lights
Fig. 6
Locking
button
Fig. 7
Push lock button