9b c – Char-Broil 463248208 User Manual

Page 20

#8-32x3/8” screw

4mm

lock washer

Control knob

bezel

Sideburner

valve bracket

Screws and Washers

removed from valve bracket

Sideburner

fascia

Valve stem

A) Insert the Electronic Ignition module into the hole of

B) Insert AA battery into ignitor module, negative (—) end first, screw on the ignition button.

C) Connect main burner ignitor wire to the terminal on backside of electronic ignition module. Connect one end of
side burner ignitor wire to side burner electrode and other end to the back of electronic ignition module.

left fascia, secure with the plastic nut.

Some components are not
shown for the clarity of
illustration

Side Burner Electrode

Side Burner Wire

Main Burner Wire

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two

#8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Install bezel with “OFF” at top.

Note: Use left and right

holes on fascia to

attach valve bracket

Note: Use upper and lower

holes on fascia to

attach bezel

20 • 463248208