Quality Chain H-Pattern Mounting and Cut Down - Manual

Step #1
(See figure 1) Lay chain out behind the tire.
Step #2
(See figure 2A & 2B) Attach rope to both side chains next to the fasteners
Step #3
(See figure 3) Put rope over the tire between the lugs.
Step #4
(See figure 4A & 4B) Drive machine forward pulling chain onto the tire
Step #5
(See figure 5A & 5B) Continue driving the chain onto the tire until the ends either meet
or overlap
NOTE; If the chain ends overlap continue on with step #6. If they do not overlap skip to
step # 9
Step #6
(See figure 5B) If the chain ends overlap you will need to cut the chain down for a proper
fit.
Step #7
(See figure 6A & 6B) Using a felt pin or paint, mark the links that will need to be cut to
remove the excess amount of chain
Step #8 Remove the chain from the tire to make your cuts and remove the excess chain
and repeat steps 1 - 4
Step #9
(See figure 7A & 7B) After cutting off excess chain and remounting, hook the inside
fastener as tight as possible and close securely.
Step #10
(See figure 8A & 8B) After securing thee inside fastener move to the outside of the tire
and secure the outside fastener taking out as much slack in the chain as possible
Step #11
(See figure 9A & 9B) Using the shackles provided hook the inside of the of the loose H-
pattern to the side chain
Step #12
(See figure 9A & 9B) Using the shackles provided hook the outside of the of the loose
H-pattern to the side chain
Step #13 You may now apply our 0296 , 0273 or 0220 chain adjusters and begin using
the chain